Planet Technology POE-1200 Manuel d'utilisateur télécharger pdf (Page 12)

Figure 2-6 Mounting thePoE Injector Hub in a Rack

Step6: Proceeds with the steps 4 and steps 5 of session 2.2.1 Desktop Installation to connect the network cabling and

supply power to your PoE Injector Hub.

2.2.3 Network Application Installation

The PoE Injector Hub is not equipment with data switching function between data ports. To inject PoE power and transmit

data packets to PDs, the PoE Injector Hub is usually link to an Ethernet switch. Typically, the Mid-Span Injector is installed

between regular Ethernet switch and PDs, and mostly it is located close to the Ethernet switch side.

To install an PoE Injector Hub on a network environment, simply complete the following step

Step1: Power on the PoE Injector Hub and connect the RJ-45 cable from the “data” port to the Ethernet switch port.

Step2: Connect the RJ-45 cable from the “d

ata + po

wer” ports to the PDs, such as VoIP phone, IP camera.

Step3: Check the link status on both PD and Ethernet switch, once the Injector start to deliver 48V power over RJ-45 cables

to PDs, the PoE In-Use LED of the PoE Injector Hub lights.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 40 41

Pas de commentaire

Planet Technology POE-1200 Manuel d'utilisateur Page 12