Planet Technology WAP-1966 Manuel d'utilisateur télécharger pdf (Page 8)

- 3 -

Chapter 2 Hardware Installation

Before you proceed with the installation, it is necessary that you have enough information about the

WAP-1966.

1. Locate an optimum location for the WAP-1966. The best place for your WAP-1966 is usually

at the center of your wireless network, with line of sight to all of your mobile stations.

2. Assemble the antenna to WAP-1966. Try to place them to a position that can best cover your

wireless network. The antenna’s position will enhance the receiving sensitivity.

3. Connect RJ-45 cable to WAP-1966. Connect this WAP-1966 to your LAN switch/hub or a single

PC.

4. Plug in power adapter and connect to power source. After power on, WAP-1966 will start to

operate.

Note: ONLY use the power adapter supplied with the WAP-1966. Otherwise, the product may be

damaged.

If you want to reset your WAP-1966

to default settings, press the Reset button 5 second. And

then wait for 10 seconds for WAP-1966 to reboot.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 56 57

Pas de commentaire

Planet Technology WAP-1966 Manuel d'utilisateur Page 8